Cisco IP Phone 7941 – reset

Power Cycle the phone and clear the configuration by holding down the # key and then plugging in the phone. After all the lights cycle on the phone, release the # key and press 123456789*0# followed with the 2 key (if you are using a 79×1, 79×2, 79×5, 7970 phone, plug the phone in and hold the # key till the extension lights blink amber…then press 3491672850*#. The lights will turn red, but if they dont, repeat this step. The phone will then wipe the flash and load whatever firmware is specified in the tftpd32 directory – if the phone just keeps downloading the term.defaults file constantly, just do an incremental upgrade to the firmware version that you want).


Comments

Leave a Reply

Your email address will not be published. Required fields are marked *